MEAS{1|2}:POW:DC/ FETC{1|2}:POW:DC (optional)
MEAS{1|2}:POW:DC? starts a new measurement and then queries the DC power of the specified phase.
FETC{1|2}:POW:DC? queries the DC power of the specified phase without starting a new measurement.
This command is valid in single-phase three-wire output (optional).
The valid modes (parameters to the OUTP:COUP command) is DC.
Command
U phase
MEASure1[:SCALar]:POWer:DC?
FETCh1[:SCALar]:POWer:DC?
V phase
MEASure2[:SCALar]:POWer:DC?
FETCh2[:SCALar]:POWer:DC?
Response
Returns the DC power of U phase in NR3 format in response to MEAS1:POW:DC? or FETC1:POW:DC?.
Returns the DC power of V phase in NR3 format in response to MEAS2:POW:DC? or FETC2:POW:DC?.
Unit: W
AC Power Supply PCR-LE series