AC power supply PCR-LE2 series
Appendix
To suddenly change the phase, specify a sudden phase change after setting the starting and ending phase angles.
We will explain using an example whose phase changes suddenly from 90° to 270° between steps 2 and 3.
Because step 2 is set to 100 ms and 25 Hz, the phase angle will end at 180° if the ending phase angle is not specified (FREE). Because we want the phase to suddenly change from 90° to 270° between steps 2 and 3, we set the ending phase angle of step 2 to 90°. Step 3 will not begin until the phase angle changes from 180° to 90°, so there will be a phase wait time.
|
STEP |
0 |
1 |
2 |
3 |
4 |
|
ACVOLT [V] AC voltage |
5.0 |
10.0 |
5.0 |
10.0 |
5.0 |
|
FREQ [Hz] Frequency |
50.0 |
50.0 |
25.0 |
25.0 |
50.0 |
|
TIME [ms] Step time |
100 |
100 |
100 |
100 |
100 |
|
OUTPUT |
ON |
ON |
ON |
ON |
ON |
|
S.PHASE [deg] Starting phase angle |
0 |
FREE |
FREE |
FREE |
FREE |
|
E.PHASE [deg] Ending phase angle |
FREE |
FREE |
90 |
FREE |
FREE |
|
PHAS.CHG Sudden phase change |
OFF |
OFF |
OFF |
OFF |
OFF |
We want the phase to suddenly change to 270° in step 3, so we set the starting phase angle of step 3 to 270° and set the sudden phase change function to on. Step 2 will end at 90°, and step 3 will begin immediately from 270°.
To use sudden phase change, be sure to set the ending phase angle of the previous step and the starting phase angle of the step in which you want the phase to suddenly change. If either phase angle is set to FREE and sudden phase change is set to on, the waveform will not change at the correct phase angles.
|
STEP |
0 |
1 |
2 |
3 |
4 |
|
ACVOLT [V] AC voltage |
5.0 |
10.0 |
5.0 |
10.0 |
5.0 |
|
FREQ [Hz] Frequency |
50.0 |
50.0 |
25.0 |
25.0 |
50.0 |
|
TIME [ms] Step time |
100 |
100 |
100 |
100 |
100 |
|
OUTPUT |
ON |
ON |
ON |
ON |
ON |
|
S.PHASE [deg] Starting phase angle |
0 |
FREE |
FREE |
270 |
FREE |
|
E.PHASE [deg] Ending phase angle |
FREE |
FREE |
90 |
FREE |
FREE |
|
PHAS.CHG Sudden phase chage |
OFF |
OFF |
OFF |
ON |
OFF |
Note that even if you set both the starting and ending phase angles, if you do not set the sudden phase change function to on, the phase will not change suddenly.
|
STEP |
0 |
1 |
2 |
3 |
4 |
|
S.PHASE [deg] Starting phase angle |
0 |
FREE |
FREE |
270 |
FREE |
|
E.PHASE [deg] Ending phase angle |
FREE |
FREE |
90 |
FREE |
FREE |
|
PHAS.CHG Sudden phase change |
OFF |
OFF |
OFF |
OFF |
OFF |
AC power supply PCR-LE2 series
Appendix